Wilfa INNOBOT Anleitung Seite 16

3. Take out the filter holder, remove the filter and clean it with the cleaning
brush.
4. Rinse the filter with clean water and allow it to air dry completely before re-
EN
installing it.
5. Rinse the dustbin compartment with clean water and allow it to air dry
completely before re-installing it. Make sure the parts are completely dry
before installing them. This is to prevent malfunction and dust clumping.
MOP
It is recommended to replace the mop with an original one every 3-6 months to
ensure cleanliness.
1. Remove the mopping module from the 2-in-1 water tank and remove the mop
from the mop holder.
2. Rinse the mop with clean water and allow it to air dry before using it again.
ROBOT
Do not use wet wipes, detergents, sprays or other chemical products to clean the
sensors, infrared recharging sensors, or charging electrode plates of the robot.
1. Use a soft and clean cloth to wipe the laser distance sensor, infrared lens,
charging electrode plates and cliff sensors.
16