Cleaning & Maintenance - Wilfa Innobot Anleitung

your robot vacuum cleaner.
• Quick map: Place the robot on the dustbin station and select this mode in the
EN
app to build a map without cleaning. After the robot automatically return to
the dustbin station, the map will be completed and saved automatically.
• Memory map: After the robot successfully completes a quick map or cleaning
and returns to the dustbin station to recharge, the map is automatically
updated and saved. After the map is successfully built, you can divide, merge
areas or customise room names in the app.
• Full house cleaning: Start full house cleaning through the app or by pressing
the power button. The robot will first carry out full house cleaning along a set
path, then carry out edge cleaning.
• Edge cleaning: Select this mode in the app for the robot to clean along the
edges of rooms.
• Area cleaning: Define a specific area in the app, and the robot will clean only
that area.
• Fixed-point cleaning: In the app; choose a target point on the map for the
robot to clean a 2x2 meter area around it.
• Scheduled cleaning: Use the app to set a cleaning schedule. The robot will
start and return to the station automatically.
• Do-not-Disturb mode: During this period (default 22:00 to 08:00), the robot
won't perform scheduled or resume cleaning and will minimize voice prompts.
You can enable/disable or set the time period of the mode in the app.
• Virtual wall/No-go area: Set up virtual walls or no-go areas to prevent the
robot from entering areas. Before using the virtual wall/no-go area function,
you need to save the map in the app. Moving the robot or major changes in
the environment can cause the original map to become invalid and result in
the loss of virtual walls/no-go areas.
• Reset Wi-Fi: When the mobile phone cannot connect to the robot, reset the
Wi-Fi by long pressing the power and recharge buttons.
• Factory reset: Press and hold the recharge button for 5 seconds until you hear
a prompt, then press and hold for another 5 seconds for a factory reset. The
robot needs to reconnect to the app, and all related settings in the app will
be cleared.
• Firmware upgrade: The robot's firmware can be upgraded through the app.
During the upgrade process, the robot must be connected to the dustbin
station or have a battery power more than 30%. Do not start a cleaning
process during the upgrade.
CLEANING & MAINTENANCE
Note: Turn off the device before performing any of the following steps!
14