Use; App Features - Wilfa Innobot Anleitung

INSTALLING THE MOPPING MODULE
1. Attach the damp mop to the Velcro on the mop holder.
2. Open the rubber cap on the water tank, fill it with clean water, and securely
fasten the cap.
3. Attach the mop to the bottom of the water tank as shown in the illustration.
4. Push the water tank into the robot until you hear a "click", indicating it's
properly installed.

USE

• Power on/off: Press and hold the power button for 3 seconds. The indicator
will light up when the robot is in standby mode.
• Press and hold the power button to turn it off, and the indicator light will turn
off.
• Start/Pause: In standby mode press the power button. The robot will begin
cleaning, and you can pause it by pressing any button.
• Manual recharge: In standby mode, press the recharge button to send the
robot back to the dustbin station.
• Automatic recharge: The robot will automatically return to the dustbin station
when it finishes cleaning or if the battery is low.
• Dust collection: When the robot is charging, the dustbin station will
automatically collect dust. If it is in Do-not-Disturb-mode, the robot will return
to the dustbin station to charge, but it will not collect dust.
• Add water or clean the mop during cleaning: If you need to add water or
clean the mop while cleaning, press the power button to pause the device.
Then, remove the water tank and mop, add water or clean the mop, and put it
back. Press the power button again to resume cleaning.
• Sleep mode: When the robot has been 5 minutes without any activity, it will
automatically enter sleep mode. If it stays in sleep mode for more than 6
hours, it will automatically turn off. To wake up the robot, press any button or
use the app.

APP FEATURES

Download the app to customize these features and maximize the performance of
13
EN