Fermax KIT WAY Installations- Und Benutzerhandbuch Seite 36

14. Setup
14.1 Unlock Time Setting
Power up within 5 seconds,
press and hold the "B"
button for 3 seconds, this
will enter the setting menu.
backlight indicator
(blinking)
Note:1. There are two ways to set the unlock time:
a) From monitor: explained in section 12.3 of the manual.
b) From doorpanel: explained in section 14.1 of the manual.
2. During timing, the backlight indicator blinking once per second, tone beeps
once per second. Less than one second by one second calculation.
-15-
A
beep + beep
B
A
Note: For 1 way doorstation, open front
cover to find button B.
Within 5 seconds, press and hold the
"A" button for 3 seconds, this will
enter the lock time settings.
backlight indicator
(off)
Press and hold the "B" button for the
time required. The length of the press
will equal the door release time (range
1~99s).
backlight indicator
(blinking once per second) beep once per second
beep