Installation; Before You Start The Installation - Ispring Rcc Serie Bedienungsanleitung

Before you start the installation

 It is highly recommended that you watch the video "iSpring RCC7 Series RO System DIY
Installation | Step by Step | Latest Edition" on YouTube.
 Choose a suitable location for the system. Again, it must be placed on a flat surface, and make
sure this system is to be installed on an INDOOR cold-water supply ONLY.
 Check the packing list to confirm that all accessories are included in the package. Contact
iSpring customer service if any components are missing.
 Required tools:
 Recommended tools:
 Variable speed drill with two bits: 1/4" (for drilling a hole on PVC drain pipe), 1/2" hollow
diamond (for drilling a hole on the counter-top for drinking faucet)
 5/8", 9/16" open-end wrench, or adjustable wrench, pliers
 Quick connect instruction:
It is highly recommended that you watch the video "How to Connect and Disconnect Quick
Connect Fittings | DIY Installation" on YouTube.
Cut the tubing end squarely using a utility knife or scissors. Insert the tubing into the quick
connect fitting for at least 1/2''. You will need to wiggle the tube and apply additional pressure
to create a seal.
WWW.123FILTER.COM | +1 (678) 261-7611 | SUPPORT@123FILTER.COM

Installation

7