Step 1: Install Feed Water Adapter (Afw43); Step 2: Install Drinking Water Faucet - Ispring Rcc Serie Bedienungsanleitung

Step 1: Install Feed Water Adapter (AFW43)

It is highly recommended that you watch the video "How to Install a Feed Water Adapter for
Reverse Osmosis (RO) and Other Applications | iSpring AFW43" on YouTube.
Step 1. a. Turn off the Cold-Water Supply Valve (CWSV) under the sink and open the kitchen
faucet to release pressure. Grab a towel or bucket to catch any water drips. Disconnect the
kitchen faucet connector pipe from the CWSV.
Step 1. b. Install the Feed Water Adapter onto the CWSV and tighten it using a wrench or pliers.
Ensure the O-ring is seated inside the adaptor.
Step 1. c. Re-install the kitchen faucet connector pipe onto the male end of the Feed Water
Adapter. Turn the handle of the Feed Water Adapter to the perpendicular OFF position. Turn
on the CWSV slowly, and ensure you get a proper seal.
Step 1. d. Connect the 1/4''
The included bushing can be threaded on either side of the Feed Water Adapter to fit the configuration
of both 3/8'' COMP and 1/2'' NPT.

Step 2: Install Drinking Water Faucet

If your kitchen sink does not have an existing 1/2" faucet hole, you can either drill a hole (Refer to
8 WWW.123FILTER.COM | +1 (678) 261-7611 | SUPPORT@123FILTER.COM
RED tubing to the Feed Water Adapter.