How To Drill A Hole In Sink Or Counter-Top; Installing The Faucet Bracket; Step 3: Install Drain Saddle (Ads1K) - Ispring Rcc Serie Bedienungsanleitung

How to drill a Hole on Sink or Counter-top) or use the enclosed faucet bracket (Refer to Installing
the Faucet Bracket).

How to Drill a Hole in Sink or Counter-top

1. You are highly recommended to watch the YouTube video "How to Drill Faucet Holes."
2. Choose a 1/2" Diamond Core Bit for granite and a titanium drill bit for steel. Do NOT use a
hammer drill on natural stone, glass, and ceramic.
3. An indent should be made with a punch on steel before drilling to help guide the bit.
4. Use caution when drilling on a Porcelain sink, as it could be easily chipped—set drill speed
on slow. Press the bit downward firmly until it breaks through the slippery surface.
5. Use a coolant to disperse the heat. Choose water for granite and oil for steel. Use the Water
Suction Cup to hold the coolant inside and prevent the drill bit from slipping.
6. Hold the drill firmly and vertically at the slowest speed to prevent the drill bit from slipping
on the counter.
7. Once you break through the smooth surface, swirl the drill a little to apply pressure evenly in
a circle. Be patient and deliberate. It can take 20 – 40 minutes to drill through 1".
Step 2. a. Wipe clean, and dry the area.
Step 2. b. Slip the front plate on the faucet stem, followed by the rubber
washer. Insert the faucet stem into the hole on the countertop. Under
the sink, slip on the back rubber washer, and tighten the nut with the
plastic wing.
Step 2. c. Slide the quick fitting up into the faucet stem, ensure it sits
securely on the base, and then lock it in place by sliding the blue
clip under the collet.
Step 2. d. Insert the
and secure it with the blue clip.

Installing the Faucet Bracket

1. Mount the bracket to the sidewall of the cabinet.
2. Insert the faucet stem into the hole on the bracket. Slip on the back
rubber washer.
3. Tighten the nut with the plastic wing.

Step 3: Install Drain Saddle (ADS1K)

It is highly recommended that you watch the video "How to Install iSpring Drain Saddle (ADS1K)
for Reverse Osmosis (RO) System | DIY Installation" on YouTube.
Step 3. a. Choose a proper spot anywhere before the P-trap on the drain pipe to install the drain
WWW.123FILTER.COM | +1 (678) 261-7611 | SUPPORT@123FILTER.COM
BLUE tubing about 1/2" into the push-in fitting,
9