Step 8: Leak Stop Valve (Als1) Installation - Ispring Rcc Serie Bedienungsanleitung

Note: The sequence of connection for different colors can be adjusted.
st
RED tubing: connect source water from the Feed Water Adapter (Point A) to the 1 Stage water
inlet elbow fitting (Point B)
BLACK tubing: connect wastewater from the Flow Restrictor (Point C) to the Drain
Saddle/drain pipe (Point D)
th
YELLOW tubing: install the T-fitting to the 5 Stage Post Carbon Filter (Point E) and then
connect it to the Storage Tank Valve (Point F)
th
BLUE tubing: connect the 5 Stage Post Carbon Filter (Point G) and the drinking faucet (Point
H)
Note: For models with AK/DI/UV filters, the BLUE tubing should be used to connect the
output of the final stage and RO faucet (Point H).
You may neatly organize the tubing, but leave enough length so the filter system can be moved
freely in and out of the cabinet when replacing filters.

Step 8: Leak Stop Valve (ALS1) Installation

The Leak Stop Valve is a reusable mechanical leakage protector. It will shut down the feed water
whenever a water leakage is detected.
Step 8. a. Make sure the end of the tubing is cut square before connecting it to the fitting.
Step 8. b. Follow the water flow direction indicated on the Leak Stop Valve to connect it to the
water inlet pipeline.
Step 8. c. Tape the bottom of the Leak Stop Valve against the floor.
WWW.123FILTER.COM | +1 (678) 261-7611 | SUPPORT@123FILTER.COM 13