Blade Maintenance - Panasonic ER1610 Bedienungsanleitung

Blade maintenance
Removing and mounting the blade
Removing the blade

1. Hold the clipper with the switch
facing upward and push the
blade with your thumb while
catching the blade in your other
hand.
•
Be sure to turn off the power
before you remove the blade.
Mounting the blade

1. Set the dial to "2.0".
2. Fit the mounting hook into the
blade mounting on the clipper
and push in until it clicks.
ER1610_EU.indb 5
Cleaning the blade
1. Brush off
any hairs
from the
clipper and
from around
the blade.
Lubrication
1. Apply a few drops of the
oil to the space between
the stationary blade and
moving blade.
•
Apply the oil to the clipper
2.0 2.0
before and after each
use.
2. Set the dial to "2.0" and
then remount the blade
on the clipper.
2. Remove the 3. Brush the hairs out from
blade and between the stationary
brush off blade and the moving
the hairs blade while pressing
from the down on the cleaning
blade edge. lever to raise the moving
blade.
5
2008/04/23 14:26:43