mspa D-AL04/06 Alpine Bedienungsanleitung Seite 16

Adjustment Buttons: PressUPor DOWN button, t hescreenflashes settingtemperature.
Re-set the temperaturewithin 3s. Otherwisethe temperature setting mode will automaticallyend.
If otherbuttonis pressedduringthe setting, the settingwill alsostopped.The currenttempera-
V
ture shown on the screen is confirmed.
NOTE: Defaultsetting temperatureis 400C; Temperature setting range: 20 - 420C
Controller Locking: Press UP and DOWNbutton at the same time for 3s, the buzzer will ring 3
times, meaning that the controller is locked. In this mode, function will not be turned on if the
button is pressed. Press UP and DOWN button at the same time again for 3s to unlock the
controller.
Timer Button: Press theTIMER buttonto enterintelligent p re-setting m ode.BypressUPand
DOWNbutton, you can set and start heating automaticallyin up to 99 hours. The TIMER setting
TIMER
is confirmedif no furtheroperationin morethan3 secondsor pressTIMERbuttonagain.The
heater will start working after current setting hours. The setting hour can also be changed by
entering the pre-settingmode again. The light of TIMER button flashes green when activated.
Cancel: Pressthe TIMER button for 3s to cancel the pre-setting.
NOTE: The pre-settingfunction cannot be turned on during heating process. The pre-setting
mode will also end after heating function is on or after the spa is reboot.
Filter Cartridge Cleaning Reminder:When red light keeps flashing (Filter function is OFF)or
red and green lights alternately flashing(Filter function is ON), the filter cartridge shall be
cleaned or replaced. After that, press Filter button for 3s to delete the reminder.
MAINTENANCE
Filter Cumulative use up to 150hrs,or cleaning
Cartridge reminder
Not in used for 2-3 days or longer
SPA
Check water quality in time and adjust to
recommendedrange
ERROR CODE CHART
LED
READING
Water temperatureis lower than zero degree
or exceed 550C
Temperature sensor failure
El immediately showsafterpressing
FILTER or HEATING
El shows 15s after pressing FILTER
or HEATING
FREQUENCY
is activated
CAUSE
Clean the filter cartridge or change a new one
Use an overall cover for protection
Usewater treatment productsto adjust
Adjust water temperature
Contact the MSpa Service Center.
Clean parts and tubes that water goes through
1. Add more water to the minimum line;
2. Clean parts and tubes that water goes through;
3. Contactthe MSpa Service Center.
16
ACTION
SOLUTION