mspa D-AL04/06 Alpine Bedienungsanleitung Seite 12

SPA SET-UP
1 Movethe entire packageto the selectedsite. Openthe cartoncarefullyas it can be usedto storethe spa
during long term storage or when not in use.
2. Lay out all the parts on the ground and make sure all parts are accounted for. Make sure the spa tub is
rightside up. (*Formissingor damagedpart,contactthe MSpaServiceCenter)
NOTE:
D-NE02: For this model, a side bar is included in
the package. Set up the wicker bar and place the
supporting legs underneaththe spa tub before
fillingthe water.It helpskeepingthe ovalspa in a
proper shape after water filling and inflation.
D.AL04/06, D.TE06, D.
LA06: Spread out the
square ground mat and
place it to the selected site
Make sure the buckle of
cover and mat is attached
when spa not in use.
3 Spa Inflation
3.1 Plug the spa into the grounded supply socket.
3.2 Press RESET button on the PRCD, the screen on controller shows numbers.
Turnthe inflationknobto the inflatingstatus<ON>and pressthe bubblebuttonon the controllerto
3.3
start inflating.After manometershows green, the inflation is complete.
3.4 Turn the knob back <OFF> and press BUBBLEbutton again to stop.
3.3
face down.
O
BUBBLE
o
12
this side
green