Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Commissioning and function
•
Set the thermostat control to the maximum setting (fully clockwise).
•
Switch on the fan heater by turning the function control to one of the three
positions.
Ventilation only (thermostat set to maximum)
I
Heating at half power (1000 W)
II
Heating at full power (2000 W)
The status light is activated. It is recommended that you first heat the room at full
power and then switch to half power to regulate the desired temperature.
•
The fan runs at the same speed at both half and full power; the difference
lies in the number of active heating elements.
•
As soon as the desired temperature is reached, slowly turn the thermostat
control back until you hear a click. The temperature is now set.
•
The fan heater switches on and off automatically to regulate the set
temperature. The status light goes out when it switches off. To increase or
decrease the temperature, turn the thermostat control clockwise or anti-
clockwise as required.
•
To switch off the fan heater, turn the power control to the OFF position (O).
The signal indicator goes out. Please note that the signal indicator only
shows whether the fan heater is in operation and not whether it is connected
to the mains or not.
•
Then pull the plug out of the socket.
Protective devices
The fan heater is equipped with a tilt safety device that switches the appliance
off if it falls over unexpectedly. If you then set it upright again, it will resume
operation.
174
Werbung
