Werbung
Verfügbare Sprachen
Verfügbare Sprachen
POWER SUPPLY
LED PIX-12
Swing Bar
The device uses an auto-range power supply that accepts input voltages between 100 und 240 volts.
1
Connect the device via the mains cable to a grounded mains socket.
2
Press the power button.
3
Do not connect the unit to the mains voltage via a dimmer.
4
The jack POWER OUT allows for power supply of further devices. To interconnect several devices,
connect the jack POWER OUT to the input POWER IN of the next unit until all units are connected.
Matching power cables with P-Con plugs are available as accessories. In this manner, up to 8 devices
can be linked at 230/240 input voltage and up to 4 devices at 110/115 input voltage.
OPERATION
After you connected the effect to the mains, the device starts running. During the reset, the motors are
trimmed and the device is ready for use afterwards. All settings remain stored even if the device is
disconnected from the mains.
The built-in control panel of the unit features four operating buttons and a display which shows all operation
statuses. The device can be operated in stand-alone mode via the control board or in DMX-controlled mode
via any commercial DMX controller. With a suitable radio receiver, the DMX control signal can also be
transmitted wirelessly to the unit. The operating modes can be selected manually by means of the display
and the operating buttons.
Operating buttons
Button
MENU
ENTER
UP
DOWN
MENU
ENTER
Function
Selects the operating mode or returns to the initial screen.
Activates a value to be modified, enters a submenu or saves a value when
modifying.
Selects the next menu item or increases values when modifying.
Selects the previous menu item or decreases values when modifying.
MENU
LED PIX-12
Swing Bar
ENTER
35/48
MENU
LED PIX-12
Swing Bar
ENTER
00156531, Version 1.1
Werbung
