Timer Playback - Panasonic Rx-5500Ls Bedienungsanleitung

TIMER RECORDING AND PLAYBACK
@ Timer Recordings of Radio Broadcasts
1) Follow the same procedure as described in step (1)~(6) of the
"LISTENING TO THE RADIO".
2) Insert the cassette into the Cassette Compartment.
3) Depending on the used cassette, set the Tape Selector.
4) Set the Dolby Noise Reduction Switch to the desired position.
5) Set the Recording Mode Selector to the "EASY-MATIC" position.
6) Set the timer to the time the recording is to start.
7) Make connections to the power source.
8) Depress the Record and Playback Levers at the same time.
After these preparations for timer recording have been completed, the
power will be turned on at the desired time, and the recording will
begin.
@ Timer Playback
1) Follow the same procedure as described in step (1)~(7) of the
section ''PLAYBACK"'.
2) Depress the Stop Lever.
3) Set the timer to the time the playback is to start.
RECORD PREVENT DEVICE
4) Make connection to the power source.
5) Depress the Playback Lever.
AC OUTLET
AS
sy
timer
After these preparations for timer playback have been completed, the
power will be turned on at the desired time, and the playback will
begin.
The tape cassette contains plastic tabs (as illustrated) to prevent
recording on an already-recorded tape cassette. The tab moves the
record interlock of this unit and permits the Record Lever to be
depressed. Recordings can be made only when the tab is intact.
There is one tab for each side (track) of the tape. If it is necessary to
preverve a valuable recording in the cassette, the tab(s) should be
broken with a small screwdriver.
If, for some reason, you want to record on a track for which the tab has
already been broken, use adhesive tape to cover the tab(s) and record
in the usual manner.
To obtain optimum performance from the set, it is advisable that the
tape oxide residue be removed from the heads periodically.
Notes:
@\f the heads are extremely dirty, clean them with a cloth dampened
with a little alcohol.
®Don't bring articles of metal, such as a screwdriver or a
magnet near the head assembly.
@Don't clean the plastic cabinet with benzine or thinner. Clean
it with a solution of soap and water.
RECORD] PLAY
Screwdriver
aap
+Q-
Adhesive tape