Werbung
Verfügbare Sprachen
Verfügbare Sprachen
12
English
3.2.15 The battery has auto reset thermal protection, which prevents charging should
the temperature be too high. Disconnect the battery from the charger for a few
minutes before charging it again. Charging will start again automatically when the
temperature has returned within the safe range of values.
3.2.16 The power supply voltage of the battery charger must match that indicated on the
technical data nameplate. DO NOT use any other type of power supply.
3.2.17 It is advisable to install a trip switch on the electrical power supply line. Consult your
electrician.
3.2.18 DO NOT damage or tread on the power supply cable. DO NOT pull the battery charger
by the cable. DO NOT pull the cable in order to unplug it from the power supply.
3.2.19 Any extension cable must have a higher section than that of the battery charger cable
and correctly sized according to its length.
3.2.20 If the machine is blocked because the battery runs out, do not continue to press the
start button, otherwise the battery fails hopelessly.
3.2.21 DO NOT fully discharge the battery. When the battery is almost discharged, recharge
it immediately.
3.3
SAFETY "MUSTS"
3.3.1 W
arning
3.3.2 W
arning
and comply with IEC 60364-1. Either a residual current device that will cut off
the power supply if the leakage current to earth exceeds 30 mA for 30 ms or a
ground fault interrupt device must be installed.
3.3.3 W
arning
3.3.4 W
arning
protection for the operator (30 mA).
3.3.5 W
arning
cross-section.
3.3.6 W
arning
3.3.7 W
arning
3.3.8 W
arning
be non-potable.
3.3.9 W
arning
out by qualified staff.
3.3.10 W
arning
machine.
. All electrical conductors MUST BE PROTECTED against the water jet.
. The electric supply connection must be made by a qualified electrician
. DURING start-up, the machine may cause network noise.
. Use of a residual current breaker (RCB) will provide additional
. Use only approved electrical extension leads with suitable conductor
. Always turn off the switch when leaving the machine unattended.
. Before pressing the trigger, GRIP the gun firmly to counteract the recoil.
. Water that has passed through backflow preventers is considered to
. Maintenance and/or repair of electrical components MUST be carried
. DISCHARGE residual pressure before disconnecting the hose from the
Werbung
