Thermalright Macho Direct Bedienungsanleitung Seite 14

Step 1:
Step 1 : Fan clips installaion
Take out Macho
color box. Pull both ends of the fan clip and
make them go through
of the heat-sink
Repeat for the other fan clip.
clips on the heat-sink
later on . Do not remove
step 3:
Step 3 : Back Plate Cap
Note: When installing on an AMD platform,
Metal Back plate, make sure you have the Cap facing downwards.
Step 4:
Step 4 : Place the motherboard
holes around the processor
pattern-Make sure the side with a washer
11
Direct Heat-sink from
holes on the corners
(as shown in the picture.)
Leave both fan
body for fan installation
them.
1
on top of the Back Plate. See the four Screw Pillars go through the four
socket. Cap the four Screw Pillars with the four Screw Nuts in a criss-cross
Thermalright
step 2:
Step 2 : Backplate
the Choose the platform (AMD) you are in use. Make four
M3LIO Screw Pillars go through the Metal Back Plate
and the Mylar film from bottom towards top. And then
place the Metal Back Plate on the table. Put the four
Washers (for AMD) around the Screw Pillars.
please first insert the Back Plate Cap into the opening on the
4
2
3
is facing the Back Plate.
AMD
o
4)
Installation
o