Silvercrest STHL 2000 C2 Bedienungsanleitung Seite 14

8.2 Putting the device into
operation and switch-
ing it off
1. Insert the mains plug 9 into a mains
socket corresponding to the technical
specifications.
2. Switch on the power supply by setting
the on/off switch 7 on the back of the
tower heater 4 to I. An audio signal
sounds. The device is now ready to use.
3. Press the 24 button to switch on the
device from standby mode. An audio
signal sounds. The device starts in fan
mode. The current temperature is shown
in the display 2.
4. Press the 24 button in order to switch
the device to standby mode. An audio
signal sounds.
NOTE: if the device is disconnected from
the mains power supply, the selected set-
tings are lost. To disconnect from the mains
power supply, set the on/off switch 7 to O
or pull the mains plug 9 out of the wall sock-
et.
5. Turn off the power supply by setting the
on/off switch 7 to O.
8.3 Fan operation
You can use the device as a fan without the
heating function.
1. Press the 24 button to switch on the
device from standby mode.
2. If necessary, press the
peatedly until L0 flashes in the dis-
play 2. The device is in fan mode.
12 GB
8.4
The device has a swivel function.
It causes the device to swivel back and forth,
thus distributing the flowing air more evenly
in the room. The function can be switched on
or off at any time while the device is in use.
• Switch on the swivel function by press-
• Switch off the swivel function by press-
8.5
NOTE: high electricity costs when in
continuous operation!
Please note that a lot of electricity is
consumed in continuous operation
(24 hours) due to the high output of
2,000 watt. At a price of 35 cents
per kilowatt hour, this would mean
costs of approx. €16.80 a day or
about €504 a month.
Use the
heat output levels:
L1
L2
• Press the
20 button re-
• Press the
Swivel function
(90° oscillation)
ing the 23 button for the swivel func-
tion while the device is switched on.
OSC appears in the display 2.
ing the 23 button again. OSC disap-
pears from the display 2.
Selecting the heat out-
put
20 button to choose between two
Device operates at 1,000 watt
Device operates at 2,000 watt
20 button repeatedly until
the desired heat output level L1 or L2 is
shown in the display 2.
20 button during operation
to show the selected heat output level in
the display 2.