ULTIMATE SPEED UPK 10 H5 Bedienungs- Und Sicherheitshinweise Seite 17

Flash mode
To switch the LED light
„
LED light will then be permanently lit.
5
Briefly press the power switch for the LED light
„
mode.
Briefly press the power switch for the LED light
„
mode. There will be 3 short flashes, 3 long flashes and another 3 short flashes.
Briefly press the power switch
„
CAUTION! Do not look directly at the LED light
PLEASE NOTE: It is not possible to turn on the light while the power bank with compressor
charging.
z Using the jumpstart feature
When using the jumpstart, make sure that at least 3 bars are permanently illuminated on the battery
level indicator .
14
1
Step
1. Connect the jump lead
of the power bank
18
with compressor to
1
the car jumpstart outlet
of the power bank
9
with compressor .
1
2. First connect the
red clamp (A) to the
positive pole of the
vehicle battery and
then connect the black
battery clamp (B) to the
negative pole
(see Fig. 1).
3. Starting up the vehicle.
on in flash or SOS mode, press the power switch
5
for the LED light once again to switch off the LED light
3
B A
2. 1.
LEDs
Red Error LED is
20
continuously lit on the jump
lead .
18
The green Start LED and the
19
red Error LED flash
20
alternately.
The red Error LED lights up
20
continuously, a short alarm
signal sounds.
The red Error LED lights up
20
continuously, an alarm signal
sounds continuously.
The red Error LED lights up
20
continuously, an alarm signal
sounds continuously, followed
by two short alarm signals.
The green Start LED and the
19
red Error LED flash
20
alternately. After 1–2 seconds
only the green LED lights up.
19
once again and the LED light
3
once again and the LED light
3
as this can damage your eyes.
5
Meaning / Error
The voltage determined in the
power bank with compressor
is not enough to start the
1
car.
Power bank with compressor
ready.
1
The temperature is too high,
possibly due to several jump
start attempts.
Battery clips (A) and (B) are
the wrong way round.
A short circuit has occurred or
the battery is leaking.
The connection is correct.
for the LED light. The
3
will switch to flash
5
will switch to SOS
5
.
5
is
1
Solution
Charge the power bank with
compressor .
1
Carry on to step 2...
Disconnect the black battery
clamp (B) first and then the
red battery clamp (A) from
the battery poles. Start
again from step 1.
Carry on with step 3...
17
GB