Moza R3 Racing Wheel and Pedals Bedienungsanleitung Seite 3

R3 WHEEL BASE
01
Connection Ports
USB
Pedal
Dash
Dimension
90.00
Xbox Console Connection Guide
1. Connect the SR-P Lite pedal set to the PEDAL port on the base.
2. Plug the power cord into an electrical outlet.
3. Plug the supplied usb cable into the corresponding ports on base and Xbox.
4. Turn on the base by pressing the power button located at the rear and then turn on the
Xbox console.
If the RPM light on the wheel flows from the side to the center, it indicates a successful
connection to Xbox. However, if the RPM light is flashing, it means you are in PC mode. In
this case, press and hold the
seconds to switch to Xbox mode.
5. If you encounter pedal travel issues during the initial use, there are two simple methods to
recalibrate the pedal:
① Calibrating in PC Mode: Connect the device to a PC and enter PC mode. Calibrate the
Power
Emergency Stop
Handbrake
Shifter
Ø3.50
S1 S2
and
Ø6.00
78.40
buttons on the steering wheel simultaneously for 3
1