Busch-Jaeger 6865AG Betriebsanleitung Seite 41

Operation
a. Program the coding of the AP receiver
For tuning one of the 6 possible transmitter modules to
the AP receiver please proceed as follows:
• Take off the casing lid of the AP receiver
• Press the programming key (Fig. 1, pos. 2) for a
moment
- the LED (Fig. 1, pos. 4) is permanently illuminated
• Enable the transmitter module/press the desired key of
the HF hand-held transmitter (the "ALL OFF" key
cannot be used for programming)
- the LED goes out for control purposes for the duration
of a received signal
- the relay switches on twice for a short time, if
programming has been successful
- the LED is permanently illuminated
• Press the programming key again
- programming is finished
- the LED goes out.
After these steps, the Busch Transcontol HF system is
ready to operate.
GB