Busch-Jaeger 6865AG Betriebsanleitung Seite 39

Install. Transmitter module/UP switch
Switch off system voltage!
The transmitter module can be installed in switch tapping
boxes behind e. g. a Busch-Jaeger UP switch. To install
the transmitter module, please proceed as follows:
• Remove the guide pin on the casing of the transmitter
module
• Connect the transmitter module acc. to the wiring
diagram shown in Fig. 4.
Notes
1. When the guide pin is removed from the casing of
the transmitter module, degree of protection remains
effective.
2. If the transmitter module is installed on other locations,
such as intermediate ceilings, a strain relief must be
provided. For this purpose, please use the clamp
included in the scope of supply.
GB