Instructions Before Installation - Dometic S7P Montage- Und Bedienungsanleitung

Instructions before installation

6 Instructions before installation
➤ Before installation, check the wall thickness of your vehicle. Consult the
vehicle manufacturer if you have any questions.
You need securing clips (not supplied) to suit the thickness of the wall
(see chapter "Preparing the installation" on page 6).
➤ With sheet metal coverings, the wall thickness must be increased to at
least 22 mm by adding a suitable mounting frame (e.g. wooden frame).
➤ When choosing the installation location, observe the following:
– Adjoining components (attachment and reinforcing parts), cables and
cabinets in the vehicle interior must not get damaged when sawing the
hole.
– Sufficient space needs to be available for installing the inner and outer
frames.
– Only install the wall window on curved wall surfaces with a radius of
5000 mm.
6.1 Pressing out the hole
See fig. 2
6.2 Preparing the installation
Supplementary to fig. 3
➤ Measure wall thickness W (A)
If the wall thickness is less than 22 mm, then you must add to the wall
section with a suitable mounting frame (B)
6
S7P
EN