Assembling The Device - Royal Catering Rcbm-11 Bedienungsanleitung

VII. Assembling the device
Before using the appliance, it is necessary to install the glass cover. To do this, follow the steps
described below.
1) Screw the support (3) to the appliance housing using two screws.
2) Install the two longitudinal rods supporting the upper section of the glass cover. Remove the
nut and insert the threaded ends of the rods (4) through the holes in the support. Finger
tighten the rods to the support.
3) Slide the rear glass cover (2) into the side support (3).
4) Install the second side support (3) to the appliance using bolts, fitting it to the rear glass
cover (2) and longitudinal support rods (4).
5) Slide the upper part of the glass cover (1) onto the side supports (3) and the support rods (4).
6) Secure the longitudinal bars connected to the side supports by tightening the nuts on the
rods.
IMPORTANT: Do not over-tighten the screws, as it may damage the glass.
EN