Neonate BC-5800D Bedienungsanleitung Seite 8

ENGLISH
Pairing (connecting) units
NOTE: PU and BU are already paired and
ready to use out of the box. Nevertheless, we
recommend you to pair the units again to ensure
a private connection.
Parent unit: Press and hold the (+) button
1
and set the ON/OFF switch to ON position.
Do not release the (+) button before (P) is
shown in display.
Baby unit: Press and hold the (+) button
2
and set the ON/OFF switch to ON position.
Do not release the (+) button before (P) is
shown in display.
Baby unit: Press (•) to confirm the pairing
3
between PU and BU. Two beeps (sound)
will confirm that the units are paired.
Both units: Turn the units off and on by
4
setting the ON/OFF switch to OFF, and then
back to ON again. The units are now ready
to use.
8
"BU#" button
ON/OFF switch
Parent unit
"PAGE" button
ON/OFF switch
Baby unit
Turning on/off and adjusting the tempera-
ture alarm
The parent unit must be turned on.
Parent unit: Press and hold the (•) button
1
for 2 seconds. You will now see degree
number flashing (or word "off") and HIGH
will appear steady in display.
Parent unit: Use the (+)/(-) buttons to select
2
the upper temperature limit. If current tem-
perature exceeds this chosen temperature
limit, the temperature alarm will go off.
HIGH
Parent unit: Press the (•) button once. You
3
will now see degree number flashing (or
word "off") and LOW will appear steady
in display.
Parent unit: Use the (+)/(-) buttons to select
4
the lower temperature limit. If current tem-
perature goes below this chosen temperature
limit, the temperature alarm will go off.
LOW