Werbung
Verfügbare Sprachen
Verfügbare Sprachen
• Fix a hexagonal
• Insert the hexagonal bit SW6 into the adapter at the knob (1).
• While scraping,
to be scraped.
• Ensure that the maximum
200 rpm is not exceeded.
• Scrape until the pre-marked
• The swarf is to be removed manually after the cordless screwdriver
switched
off.
Disassembly
6.
• For disassembling
be arrested.
• Press the blade holder (3) and rotate the detent (2), as previously described.
• Remove the scraper tool FWSG RA from the pipe end.
7.
Inspection
Inspect the scraping result, i.e. the swarf must be completely
markings applied before with the FRIALEN marker may no longer be visible.
For bundled coil pipes control the scraping
thickness
or remained marks on the pipe very carefully.
The blade is adjusted for a swarf strength of 0, 15 - 0,25 mm. For the scraping
of FRIALEN safety fittings the wear limit is max.
ceeded. Please note differing requirements
abrasion of the blade can enlarge the swarf thickness
Sion occurs because of multiple usage and outside influences
Therefore the strength of the swarf must be measured regularly - e.g. with a
calliper gauge.
NOTICE
An incomplete
scraping
fusion
joint.
bit SW6 at the cordless screwdriver.
press the cordless screwdriver
permissible
surface of the pipe end is completely
of the scraper
of the scraping tool FWSG RA the blade holder (3) has to
of the scraping
or a differing
axially against the pipe end
number of rotations per minute of
tool
result
result with regard to the swarf
mm and must not be ex-
of other fitting manufacturers.
inadmissibly.
swarf thickness
may result
scraped.
was
removed and the
An
This abra-
(sand, soil etc.).
in a leaking
15
EN
Werbung
