FRIATEC Friatools FWSG RA Serie Bedienungsanleitung Seite 13

3. Preparation
• Remove any dirt such as sand and soil from the pipe surface to be scraped
(e.g. using a clean, fat-free cloth).
NOTICE
If the pipe surface
prematurely!
• If a fitting has to be fused, mark the insertion depth on the pipe end with a
FRIALEN marker pen.
• Mark the area to be scraped with a FRIALEN marker pen using wavy lines.
In case of bundled coil pipes particularly
(this is for you to determine whether pipe has been scraped completely)
4. Assembly
• Before the assembly
to be arrested.
• Hold the scraper tool FWSG RA in the hand and press the blade holder (3)
with the thumb in direction
• The blade holder (3) is lifted from the mandrel (5).
• Rotate the detent (2), e.g. by a rotational
of scraping
to be scraped is not cleaned,
of the scraper
of the scraper tool FWSG RA the blade holder (3) hast
of the base body (7).
• Position the blade above the collar of the mandrel (5);
eventually rotate the mandrel (5) in this position.
• Insert the mandrel (5) into the pipe end to be scraped,
that the scraping tool FWSG RA has secure grip.
• Align the blade such that the edge is positioned
the pipe end.
• Press the blade holder (3) and relaese the detent (2), as
previously described.
the scraper blade wears
the inside curve has to be marked
tool
movement of the wrist.
EN
above
13