TROUBLESHOOTING MOTOR ADJUSTMENT
Cause
The COMPACT motor adjustment is fi tted with
overheating protection
Overheating has caused it to stop the motor
adjustment
There is an internal fault in the COMPACT
motor adjustment
Code
Description
00
Internal error channel 1
01
Internal error channel 2
02
Internal error channel 3
12
Defect Channel 1
13
Defect Channel 2
14
Defect Channel 3
Code
Description
24
Overcurrent motor M1
25
Overcurrent motor M2
26
Overcurrent motor M3
48
Overcurrent motor group 1
49
Overcurrent motor group 2
60
Collision protection
61
Overcurrent motor adjustment
Note: the motor adjustment COMPACT can be parameterized so that a manual reset must be carried out after an overcurrent error (E24,
E25, E26, E48, E49 and E62)�
Code
Description
Plug detection in M1 motor
36
socket
Plug detection in M2 motor
37
socket
Plug detection in M3 motor
38
socket
61
Actuator changed
Synchronization lost motor
55
group 1
Synchronization lost motor
56
group 2
Remedy
The display reads HOT
Wait until the motor adjustment has cooled down and HOT is no
longer displayed
The COMPACT motor adjustment is then operational again
The display reads E + an error code
Proceed as indicated in the following error list
Remedy
Unplug power cord and contact the customer service� Have the
order confi rmation and deck type ready for this purpose (see
type label)
Unplug the motor adjustment
Fix the external short circuit
or
Plug in the correct motor to the motor socket that shows the
error
Start the motor adjustment again
Remedy
Remove jammed objects from the driving area
Desk might be overloaded: remove load from desktop
Contact customer service. Have the order confi rmation and
deck type ready for this purpose (see type label)
Remedy
Plug in the correct motor to the motor socket that shows the
error
Reset all motors
Remove load from desktop
Reset all motors;
if error occurs after reset again, contact customer service� Have
the order confi rmation and deck type ready for this purpose
(see type label)
25