2. Operating Instruction
The following warning symbols
together with the following words
•
Danger!
•
Warning!
•
Attention!
describe the risks of non-compliance with the instructions in this manual and the associa-
ted operating instructions.
3. Safety Instruction
When using the power tool, the enclosed safety instructions and the additional safety instructions
must be observed.
The following symbols are used in this guide:
Attention: Risk of injury or
possible damage to the power
tool..
Keep people and / or animals
away from the work area.
Do not use the machine to pull
people.
Do not leave people between
the vehicle and a towed load.
Do not stand yourself between
the vehicle and a pulled load.
4. Winch operations warnings
Read the following carefully before attempting to operate your winch and keep the instructions
for future reference.
1. The uneven spooling of cable, while pulling a load, is not a problem, unless there is a cable pile
up on one end of the drum. If this happens reverse the winch to relieve the load and move
your anchor point further to the centre of the vehicle. After the job is done. you can unspool
and rewind for a neat lay of the cable.
2. Store the remote control switch inside your vehicle where it will not become damaged, inspect
it before you plug it in.
3. When ready to begin spooling in, plug in remote control switch with clutch disengaged, do not
engage clutch with motor running.
4. Never connect the hook back to the cable. This causes cable damage. Always use a sling or
Do not use the machine to lift
or wrap loads.
Make sure the rope is not tang-
led.
Always allow at least 8 turns of
rope around the cylinder.
Read the instructions carefully.
14