After Use; Technical Specifications; Troubleshooting - Donnerberg Lexa Originalbetriebsanleitung

After use

1. Press O button on the control panel to disable all functions.
2. Tum off the power switch (to "O") located at the back of the chair.
3� Remove the plug from the power socket�
Notice: Please do not pull on the power cord to detach the plug.

Technical specifications

Product name
Product model
Type of Product
Power Voltage
Power Consumption
Operating Frequency Band
Maximum transmission power (EIRP) 0,89 dBm
A-weighted sound pressure level
Auto Timer
Product Dimension
Box Dimension
Net / Gross Weight
Hereby, Donnerberg declares that the radio equipment type (Bluetooth module and Bluetooth speakers integrated in the LEXA mas-
sage chair) is in compliance with Directive 2014/53/EU. The full text of the EU Declaration of Conformity is available at the following
internet address: https://www.donnerberg.net/en-gb/products/massage-chair

Troubleshooting

This page summarises the most common problems you would encounter with the product� If you are unable to solve the problem with
information below, please contact the Donnerberg Service Centre.
PROBLEM
The product is not plugged in properly�
The product has just finished its 15-minute
auto-timer session; the chair will stop massaging
The product does not
and remain in its current position.
work�
You may have used the product continuously for
more than 30 minutes and the overheat protec-
tion has been activated.
An excessive load has been applied on the
product�
The product is
The product is likely to be overused�
abnormally warm�
The heating pad has overheating protection.
The heating tem-
When turned on, the heating temperature will
perature is different
stop when it reaches the set level�
on both sides�
If the temperature drops, it will be reheated�
The product is
Noise is made by the mechanical parts of the
producing audible
product�
noise�
28
LEXA
LX - 095
LX - 096
Massage Chair
220V-240V- 50/60HZ
150W
2,402GHz-2,480GHz
< 70 dB(A)
15 min
Upright: Approx 1330 (L) x 750(W) x 1140(H) mm
Reclined: Approx 1560 (L) x 750(W) x 1000(H) mm
Approx� 1170 (L) x 770 (W) x 1140 (H) mm
Approx� 78 / 94 kg
POSSIBLE CAUSE SOLUTION
Ensure the voltage on the product corresponds to the
local mains voltage and then plug in again� Then press
on the power switch�
Press the ON/OFF button, and the chair will return to
the upright position. If you want another session, press
the ON/OFF button again.
Unplug the product and let it cool down for 60 minutes
before you use it again�
Reduce the excessive load and start again�
Unplug the product and let it cool down before using it
again�
Unplug the product and allow it to cool down before
using it again�
This is normal and does not mean that the product is
faulty�