Donnerberg Lexa Originalbetriebsanleitung Seite 22

3. Place the chair in an open area
• Please ensure that there is a clearance of at least 8cm around the chair to allow for reclining�
• To avoid damage to the floor and to reduce noise, please put a rug under the chair.
• Make sure that there is no barrier at the front and the back of the chair�
• Please do not put the chair on wet or uneven floor.
• To avoid signal interference, please position the chair at least 1 meter away from any nearby TVs and radios.
• Avoid exposing the chair to direct sunlight or placing it in high-temperature areas� Otherwise it may cause the leather to fade or
harden�
Warning:
Do not place the power cord under the chair!
Beware of damaging the power cord while moving the chair!
4. Move the chair
Wheels
Tilt the front part of massage
chair
5. Check the space around the chair
22
• As illustrated, push the backrest downwards and tilt the chair on to its wheels at a 45° angle.
• Slowly push and move the chair to the desired location.
• Lower the chair slowly and smoothly until it is fully flat on the ground.
Warning:
• Before moving the chair, please adjust the footrest back to its original position.
• Do not move the chair when occupied or in use�
• Moving the chair may cause damage to the floor.
• Floor protection is recommended (e.g. rugs or carpet).
• Do not drop or suddenly let go of the chair when moving as it may damage the chair�
• Two persons are recommended when moving the chair and extra care is required�
Make sure there is no person, pet or other object close to the chair�