Before First Use; Use - Genius Invictus F7 Gebrauchsanleitung

GB

Before first use

NOTE!
DANGER OF DAMAGE!
If you open the packaging carelessly with a sharp knife or other pointed objects, the
appliance may be damaged.
Open the packaging carefully.
„
1. Remove the appliance from the packaging.
2. Check that everything has been included.
3. Check whether there is any apparent damage to the appliance or its single components. If this is the case, do not use
the appliance. Contact the customer service address given in the Customer Service section.

Use

NOTE!
DANGER OF DAMAGE!
Improper handling of the appliance may result in it being damaged.
Make sure that the tanks are inserted correctly and the clean water tank is full before switching on the appliance.
„
To avoid blocking the air inlet, remove coarse dirt before using the appliance.
„
Prepare the appliance:
1. Remove the clean water tank from the appliance (see fig. A).
2. Remove the cover and fill the tank with clean water (see fig. B). Observe the max line, do not overfill the tank. To
enhance the cleaning effect, you can add a few drops of a suitable cleaning agent.
3. Reinsert the clean water tank into the appliance (see fig. C).
4. Attach the desired brush to the hose (see fig. D).
5. If necessary, connect the hose to the main appliance. Unwind the cable completely from the appliance (see fig. E).
Use
1. Connect the appliance to a functioning and properly earthed socket (see fig. F).
2. Press the main switch on the back of the appliance. Set it to „I" (see fig. G).
3. Switch on the appliance by touching the on/off button on the control panel (see fig. H).
4. The „Power" button allows you to choose between standard and turbo suction power (see fig. I). You can use the
„Temp" button to select whether you want to clean with warm (40 °C) or hot (60 °C) water (see fig. J).
5. Press and hold the spray button to moisten the upholstery/dirt (see fig. K). As soon as you release the spray button,
no more water will come out.
6. Thoroughly vacuum the water from the upholstery (see fig. L). Then allow it to dry completely. When the dirty water
tank is full, a signal will sound, all LEDs on the control panel will light up, and the appliance will switch to standby.
7. Touch the on/off button to put the appliance into standby mode (see fig. M).
8. Switch off the appliance at the main switch (see fig. N).
9. Disconnect the appliance from the power supply. Wrap the cable around the cable storage unit (see fig. O).
10. Remove, empty and clean the dirty and clean water tanks (see fig. P).
18
Instruction manual