Silvercrest RHYTHM LIGHT Bedienungs- Und Sicherheitshinweise Seite 36

˜ PartyPlay function
PartyPlay is a new feature that allows you to connect more than 2
speakers together and up to a total of 10 speakers to play music at
the same time.
NOTE: Only SilverCrest branded Bluetooth speakers with this
PartyPlay function can work together.
NOTE: The product which had its PartyPlay
pressed first will become the "primary" unit and the other unit will
then by default become the "secondary" or "additional" unit. The
playback device can only be controlled with the primary device.
Also, the volume of all speakers can only be changed with the
primary unit.
To enjoy the Partyplay function, you can connect more Partyplay
compatible products together and up to 10 speakers can be
connected together by using the Partyplay
Step1: Turn on a loudspeaker which will then by default be set as
the "primary" device and then connected to the playback device
via Bluetooth first. A beep sound will emit out and the LED 12 will
flash white for 2 seconds then change to RGB breathing mode once
connected successfully.
Step2: Press the PartyPlay
until the signal tone sound is emitted and the LED 12 will stay on
during PartyPlay pairing.
Step3: Press briefly the PartyPlay
the LED 12 of the second speaker will breathing white and a signal
tone sounds will emit out once connected successfully. The playback
device can only be controlled with the primary device. Also, the
volume of all speakers can only be changed with the primary unit.
To integrate additional speakers, the Partyplay
must be pressed once on the additional speakers. Make sure all
the speakers must all be within Bluetooth range approx.10m.
Press and hold the Partyplay
the Partyplay pairing connection, the LED 12 on the connected
secondary/ additional units flash and a signal tone sequence
sounds.
˜ Cleaning
Switch the product off and remove all cables before cleaning.
Only clean the outside of the product using a clean, dry cloth
for cleaning the product and never use any corrosive liquids /
abrasive cleaning agents. Use a slightly moistened cloth and a
mild cleaning agent to remove stubborn dirt.
When cleaning the speaker, the USB/AUX-IN cover should be
closed.)
button 7 .
button 7 of the primary device
button 7 of second device,
button 7 again to break
button 7
button 7
GB/IE 37