Silvercrest RHYTHM LIGHT Bedienungs- Und Sicherheitshinweise Seite 33

˜ Establishing a Bluetooth
Remove all plugs from the AUX-in jack 2 before you attempt to
establish a Bluetooth
Switch on the playback device and make sures its Bluetooth
mode is on.
On the product press the
LED 12 flashes white and a signal tone sequence sounds. The
product will now attempt to connect to the playback device (e.g.
smartphone or computer).
The product identification on the playback device will be
"RHYTHM LIGHT". On the playback device "ACCEPT" the
connection. Please note the requirements of the software on the
playback device.
Once the connection is made the LED 12 will light up white and
a signal tone sequence sounds.
The maximum range of the connection is approx. 10 m,
but this may be reduced due to the geometry of the space
(obstructing furniture, walls, etc.).
The playback device must support Bluetooth
otherwise you may not be able to use all the functions.
˜ Functions of the buttons
Start a playlist on your playback device.
The product has 7 buttons and these control the following
functions:
Button
34 GB/IE
connection.
®
Function
‒ Press to switch the product ON or OFF.
‒ LED effect lamp ON/OFF button
Press to turn ON the RGB breathing lamp. Tap
again to change your color preference, total 7
color mode. After that press again to turn OFF LED
lamp effect.
‒ Press briefly during playback to pause or continue
playback.
connection:
®
button 6 for 2 seconds until the
standard 5.3
®
®