Silvercrest RHYTHM LIGHT Bedienungs- Und Sicherheitshinweise Seite 35

˜ Connecting via the AUX-in jack
NOTE: Music playback via the AUX-in jack 2 has a higher
priority over a Bluetooth
Once the AUX cable 16 is plugged into the AUX-in jack 2 ,
the Bluetooth
playback is now switched to AUX-in only and the LED 12 lights
up green.
If the product is off, press the
12 lights up green and a signal tone sequence sounds.
Switch the playback device on and start playback.
Set the highest possible volume on the playback device. Then
adjust the volume with the +/- buttons
˜ Switching between AUX-in
and Bluetooth
To resume music playback via Bluetooth
AUX cable 16 from the AUX-in jack 2 . The product will then
search for the previously paired playback device (if any) and
re-establish the Bluetooth
˜ True Wireless Stereo TWS pairing
NOTE: This function is only available if two of these products
have been purchased and both have the same model number.
Turn on both speakers and make sure they are both not
connected to another device via Bluetooth
neither of the speakers is actively coupled with a playback
device.
Press the
by default set it as the "primary" unit. A beep will sound. When
pairing between both products has been carried out successfully,
the LED 12 of the connected "secondary" unit stops flashing and
a sequence of beeps will sound.
The "primary" unit LED 12 will still be flashing waiting to
pair with the playback device. Once the "primary unit"
has successfully paired with the playback device both the
"primary" and "secondary" units can be played and controlled
synchronously during Bluetooth
Press the
connection, the LED 12 on the connected "secondary" unit
flashes and a signal tone sequence sounds.
NOTE: The product which had its
become the "primary" unit (in the left audio channel), and the other
unit will then by default becone the "secondary" unit (in the right
audio channnel).
36 GB/IE
connection.
®
wireless connection will be disconnected. Music
®
connections
®
®
button 6 on one of the products which will then
button 6 again to break the TWS pairing
button 4 until the signal LED
10 9
®
connection automatically.
playback mode.
®
button 6 pressed first will
on the speaker.
connection unplug the
. At this moment,
®