Indesit KP 968I MS (X)/DE Gebrauchs- Und Installationsanleitung Seite 9

The oven gives nine different heating element combinations;
so the most suitable type of cooking for each dish can therefore
be chosen, with convincing results.
By turning the selector knob "G" marked with the symbol
, different cooking functions are obtained, as shown in the
table on the right.
Symbol Function
0
0) Off
1) Top + Bottom heating elements
2) Bottom heating element
3) minigrill element
4) Grill heating element
5) MaxiGrill heating element
6) MaxiGrill heating element + fan
7) Bottom heating elements+fan
8) Rear round heating element + fan
9) Fast defrosting
After having selected the cooking function, set the thermostat
knob "H" marked with the symbol
required.
• For traditional cooking (roasts, biscuits, etc.) in
conventional
mode use the function
below).
Only put the food to be cooked into the oven when it has
reached the selected temperature and preferably use just
one shelf for cooking.
To provide heat only to the bottom or the top part of the
dishes, turn the selector to the position
(hot above).
• With this function (fan assisted) heat is transmitted to
the foods through pre-heated air made to circulate inside
the oven by a fan. The oven heats up very quickly so the
food to be cooked may be put into the oven as it is switched
on. Cooking is also possible simultaneously on both shelves.
• The "fast defrosting" function
elements, just the oven light and the fan.
• Grill operation: a high heat output is used for grilling, so
that the surface of the food is immediately browned; this is
particularly indicated for meats which should remain tender
on the inside. To grill, turn the selector knob "G" to the
position
(Grill),
Power
2350 W
1300 W
1050 W
2000 W
3050 W
3100 W
1350 W
2850 W
50 W
C
°
to the temperature
(hot above +
(hot below), or
uses no heating
+ fan).
(Maxigrill), (Maxigrill
How to use
During grilling, do not set the thermostat knob to over
200 °C and keep the oven door closed (not even in the
minigrill mode).
The oven light comes on automatically when the selector
knob is turned to any of its positions.
Indicator light "S"
It indicates that the oven is heating up. When the light
goes out, the required temperature has been reached inside
the oven.
-
When the light alternately comes on and goes out, it means
that the thermostat is working properly to maintain the
oven temperature constant.
Spit - Rotisserie
This accessory is to be used exclusively when grilling
food. Proceed as follows: insert the meat to be cooked
along the length of the spit rod, securing it with the special
adjustable forks (fig.5a).
Introduce the supports "A" and "B" (fig.5b) into the holes
in the drip tray "E", rest the rod groove on the seat "C"
and insert the oven rack into the lowest guide of the oven;
now insert the spit rod into the relative hole, moving the
groove forward into seat "D". Start the grill and the
rotisserie by turning the thermostat knob "G" to the position
with the
fig.2
Cooling ventilation
In order to cool down the temperature of their exterior, some models
are fitted with a cooling fan that comes on when the programme selec-
tor knob "G" is turned. In this case, the fan is always on and a
normal flow of air can be heard exiting between the oven door and
the control panel.
Note: when cooking is done, the fan stays on, even if knob "G"
is set to "0", until the oven has cooled down sufficiently.
In "Fast cooking" mode, the fan comes on automatically only when
the oven is hot.
Once you have removed the food from the oven, we recommend
you leave the oven door ajar for a few minutes: this will drastically
reduce the duration of the cooling cycle. The process is controlled
by an additional thermostat and can consist of one or more cycles.
7
symbols.
fig.3