Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Danger:
- To ensure consistently good suction power, the dust bag must be changed in good
time and the filters must be cleaned regularly or replaced after some time .
- Never operate the vacuum cleaner without a bag and filter.
Change dust bag:
The dust bag indicator is located on the top cover. This is green as long as the dust bag has
enough capacity. If the dust bag indicator is red, a new dust bag must be inserted:
- Disconnect the device from the power supply.
- Remove the suction hose.
- Press the top cover opener and lift the cover until it clicks into place.
- Remove the holder with the dust bag upwards from the device.
- Remove the full dust bag from the holder and dispose of it in household waste.
- Insert the box of a new dust bag into the holder.
- Insert the new dust bag with the holder back into the device and close the cover so that it
audibly clicks into place.
A notice: If the dust bag holder has not been pushed in completely, the cover cannot be
closed!
Dust bag:
- Never use the device without a dust bag!
- A suitable dust bag type is available for this model:
Swirl ® Y 45® (not included).
Clean / replace filter:
There are 2 different filters in the device:
Motor filter: This protects the motor from dust and is located inside the device.
-
Exhaust filter: This filters the exhaust air before it leaves the device and is located on
-
the back of the device behind the removable ventilation grille.
1. Engine filter:
Remove the dust bag and holder as described previously.
On the back wall of the inside there is a cover grille that can be folded forward
Remove the fleece filter and clean it in lukewarm water. Let it dry completely, put it back
into the cover grid and put it back in its intended position.
Maintenance and care
17
Werbung
