Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Cable:
1. Pull out the cable. Pay attention to the yellow or red marking on the cable. The cable may
only be pulled out as far as the red marking (!).
2. To rewind the cable, press the cable winder. This can also be operated with your foot. The
cable is automatically retracted. Hold the plug firmly with your hand to prevent the cable
from flying around.
Turn device on/off:
1. Insert the power plug into the socket.
2. Press the power button to turn on the device.
3. If you want to turn the device off again, press this switch again.
4. Unplug the device when you have finished using it.
Vacuuming:
Important NOTE:
The device may only be operated if a dust bag and the two filters (see information below) are
installed. The dust bag and filter are installed at the factory.
If no dust bag is installed, the top cover cannot be closed. Do not try to close the cover by
force, as this may damage the device.
If no filters are used there is a risk of contamination.
Any resulting damage is excluded from any warranty!
- Move the floor brush across the floor in even movements.
- Adjust the suction power by turning the control:
Min: Low suction power, e.g. for curtains, upholstered furniture
Max: High suction power, e.g. for carpets or rugs
Medium suction power, e.g. for parquet or laminate floors.
- The suction power can also be adjusted by the airflow regulator. Slide the regulator up to
reduce the suction power, slide it down to increase the suction power.
Accesories:
Nozzle for joints, corners, radiators, drawers, etc. with fold-out brush;
Fold the brush forward or backward depending on what function you want to
use the nozzle for.
Operation
16
Werbung
