elero AstroTec-868 bidi Bedienungsanleitung Seite 94

Troubleshooting/
General declaration of conformity
Troubleshooting
Problem Cause
The sun and twilight No light sensor is
parameters cannot be connected or the light
changed and/or are sensor and/or the
not displayed. connecting cable
is faulty.
Roller shutter does No end limit position is Set the end limit
not move to the end set.
limit.
Transmission control Batteries are low.
light is flashing.
Transmitter doesn't Power supply was
respond following interrupted for
battery replacement. too long.
General declaration of conformity:
The company elero GmbH hereby declares that the
AstroTec-868 is in conformity with the basic requirements and
other relevant provisions of the Directive 1999/5/EC.
EN-42
Remedy
Check the light sensor,
connecting cable and
connector plug.
position using the
setting menu
PROG1/2.
Replace batteries.
Press RESET button.
Check settings.