elero AstroTec-868 bidi Bedienungsanleitung Seite 72

Program transmitters/program end positions
AstroTec-868
Note: Below is the programming/deleting procedure for the
unidirectional version; the procedure for the bidirectional
version takes place from page 22
Programming radio channel settings
Programming transmitter/channel
Prerequisite: The drive must be installed.
1. With pre-installed electric receivers, the fuse must be
disconnected and reconnected after a few seconds.
The drive will then remain in programming mode for
approximately 5 minutes.
2. Position yourself in front of the roller shutter/blind with the
AstroTec-868 in your hand
LR03 (AAA)
Programming button P
4. To define the keyboard layout, press the UP button of the
AstroTec-868 (located on the front of the device) as soon as the
shutter/blind begins to move upwards (after approx. 1 second).
The shutter/blind will come to a halt briefly.
As soon as the shutter/blind begins to move again, press the
DOWN button on the AstroTec-868.
The shutter/blind will come to a stop.
The AstroTec-868 has been successfully programmed.
EN-20
3. Press programming button
P on the back of the device
briefly. The shutter/blind
will automatically begin to
move up and down. This will
happen for approximately
2 minutes.