elero AstroTec-868 bidi Bedienungsanleitung Seite 75

Program other AstroTec-868 bidi transmitters
Delete AstroTec-868 bidi transmitters
Programming further transmitters
If you wish to program other transmitters to the receiver you can
proceed as follows:
1. On a transmitter, which has already been programmed to the
receiver, press the UP, DOWN and the programming button P
until the LED goes out.
2. Press the programming button P on the back of the device briefly.
The shutter will automatically begin to move up and down for
approx 2 minutes.
3. In order to define the keyboard layout, press the UP button (front
of the device) on the AstroTec-868 bidi immediately (max. 1 sec-
ond) after beginning upward motion; the status of the bidirectional
programming is acoustically signalised.
The roller shutter stops briefly and then continues to travel again.
Press the DOWN button on the AstroTec-868 bidi immediately
after beginning downward travel; the status of bidirectional pro-
gramming is acoustically signalised.
The roller shutter stops.
The AstroTec-868 bidi is now programmed.
Deletion of individual transmitter
1. Simultaneously press programming button P (rear of the device)
and the STOP button (front of the device)
2. Keep this button combination pressed until the LED goes out
briefly for a second time (approx. 6 s)
Deletion of all transmitters
1. Simultaneously press the programming button P (rear of the
device) and buttons UP and DOWN and STOP (front of the
device)
2. Keep this button combination pressed until the LED goes out
briefly for a second time (approx. 6 s)
EN-23