elero AstroTec-868 bidi Bedienungsanleitung Seite 70

Explanation of functions
PRIORITY (factory setting priority = OFF, only visible in expert
mode)
If the priority is switched to "ON", the clock has a higher priority and
overrides the manual-automatic sliding switch setting of the hand-held
transmitter programmed in the receiver.
Clock commands are executed even if the manual-automatic sliding
switch of the hand-held transmitter programmed in the receiver is set
to " ".
If the manual-automatic clock sliding switch is set to " ", no clock
commands will be executed.
If the priority is "OFF", clock commands are only executed when the
manual-automatic sliding switch of the hand-held transmitter pro-
grammed in the receiver is set to " ".
SHADING (factory setting shading = OFF, only
visible in expert mode)
If shading is switched to "ON" the automatic shading system is
switched off with the " " clock command.
The automatic shading system is switched on by the „ " clock
command.
PREREQUISITE!
The manual-automatic selection switch of the programmed
transmitter has to be set to „ ".
As long as the manual-automatic sliding switch of the programmed
transmitter is set to " " , the automatic shading is always switched off
and is not affected by the timer.
If shading is switched to "OFF", then the automatic shading system is
not influenced by the clock.
EN-18