Werbung
Verfügbare Sprachen
Verfügbare Sprachen
- Do not squash or hit the mesh with sharp objects or brush.
- Do not use the appliance without installing the filter.
Storage
Please store the air conditioner properly if not in use.
1. Screw off the drain cover and pull out the stopper to drain
condensate water completely. Or tilt the unit to drain water.
2. Keep unit running in fan mode for half day to dry inside of unit
completely to prevent from going moldy.
3. Turn off the unit, pull out the plug then wrap the power cord
around the wire-winding pillar, insert the plug into the universal
fixing hole at the back panel of the unit, install the water stopper and
drain cover.
4. Remove the heat exhaust hose to assembly, clean and keep it
properly.
5. Take out the batteries from remote controller and place it in the
remote control box.
Notes:
Assure the unit is stored
in a dry place. All
accessories of the unit
shall be protected
together properly. Keep
the unit away from
children.
26
Pull Out
TROUBLESHOOTING
Please refer to below chart if you have any questions during
operating.
Trouble
Cause
The unit fails to
Power supply failure
start up
Water-full and its icon
lighting
Ambient temperature
too low or low high
The room
temperature is lower
than the set
temperature in
cooling mode
Bad cooling
There is direct
effect
sunlight
The doors and
windows are open,
the room is crowded
or there are other
heat sources
Dirty filter
Air inlet or air outlet
clogged
Solution
Connect the unit to a
live socket and turn it
on.
Drain the water
stored in the unit.
It is recommended to
use this unit between
5°C-35°C
Change the set
temperature
Close the window
curtain
Close the door and
window, remove other
heat sources, and
add new
air-conditioners
Clean or replace the
filter mesh
Remove the
obstruction
27
Werbung
