Pre-Installation Requirements; Selection Of Installation Equipment / Dimensions - Pkm In4-2Fzsa Bedienungsanleitung

Pre-installation requirements

The installation of the induction hob must meet the safety
requirements as well as the legal rules and regulations.
➢ The worktop must be rectangular and plane and made of heat-resisting material.
Structural elements should not interfere with the installation area.
➢ The thickness of the worktop for the installation of the induction hob must be at
least 30 mm.
➢ The wall sat the induction hob should be covered with heat-resistant material, e.g.
ceramic tiles.
➢ During operation of the induction hob, adjacent furniture or housing and all
materials used for installation must be able to resist a temperature of min. 85 °C
above the ambient temperature of the room the appliance is installed in.
➢ The power cable must not come into contact with cabinet doors or drawers.
➢ The appliance must be supplied with an adequate flow of fresh air from outside
the cabinet to the base of the induction hob.
➢ If the induction hob is installed above an oven, the oven must be equipped with
a cooling system.
➢ Install a thermal protection below the bottom of the appliance when installing it
above a drawer or a cupboard.
➢ The circuit breaker must be easily accessible.

Selection of installation equipment / Dimensions

➢ Cut out the installation opening as described on the drawing below. Check the
cut-out size with a ruler before cutting out the worktop.
➢ For installation and use, a minimum of 50 mm space shall be preserved around
the installation opening.
➢ The thickness of the work top should be at least 30 mm. Choose heat-resistant
materials for the work top only to avoid any deformation caused by the heat-
radiation of the appliance.
D
IMENSIONS OF THE INDUCTION HOB
All dimensions are given in millimetres.
L (mm) W (mm)
590 520
(
THE INSTALLATION OPENING
H (mm) D (mm)
62 58
~
68
IN4-SA
MODELS
A (mm)
560+4 490+4
~
+1
IN4-2FZSA)
AND
B (mm) X (mm)
mind.50
+1
AND