Werbung
Verfügbare Sprachen
Verfügbare Sprachen
GARANT INFO Point, computer desk, computer workstations
de
Qualification / training in the field of mechanics as specified in the nationally applicable regulations.
Trained specialist for electro-technical work
A trained electrician in terms of this document is a person who has been respectively trained and who possesses the skills
and experience to recognise and avoid the dangers of working with electricity.
en
Trained person
Trained persons in the sense of this documentation are persons who have been trained to perform work in the areas of
transport, storage and operation.
cs
5.
Transport
Immediately on receipt check the product for damage in transport. Damaged products must not be installed or commis-
sioned. Pallet delivery. Transport on pallet using suitable lifting gear. Do not lift cabinet off pallet alone. Before transporta-
da
tion to a different installation location, fully empty the cabinet.
CAUTION
Risk of injury during transport
es
Risk of injury from improper transport to installation site.
»
Wear foot protection, safety gloves and safety helmet.
»
Do not transport alone.
fi
»
Make sure the paths for movement and transport are clear.
»
If features, release parking brake on castors and apply before work.
»
Transport with drawers and doors closed, locked and additionally secured.
fr
NOTICE
Improper transport
Damage to items of packaging.
it
»
Handle items of packaging in accordance with the symbols and instructions shown on them.
»
Do not drag them across the floor.
»
When items of packaging are being transported they must be upright, secured with ropes and protected against slip-
ping.
hr
»
Be aware of the centre of gravity.
»
Use the lifting points provided.
»
When putting them down, do so slowly and evenly.
hu
»
Do not remove the transport packaging until immediately before erection.
»
Once the device has been erected at the place of erection, remove the transport restraints.
6.
Setting up
lt
Set up on a solid, level floor with maximum load-bearing capacity.
For stationary workstations, check horizontal levelling with spirit level. If necessary Adjusting adjustable base
[} Page 22] or use shim wedges.
nl
Article no. 948121 and 948122: Maintain a gap of at least four cm between cabinet rear and wall.
Ambient temperature: -10 °C to +40 °C.
6.1.
ADJUSTING ADJUSTABLE BASE
pl
NOTICE
Limited load-bearing capacity
Damage from overloading adjustable base.
ro
»
When using the adjustable base, note load-bearing capacity reduced to 500 kg.
»
Before adjusting the adjustable base, completely clear out the cabinet.
»
Do not screw the adjustable base's thread all the way in. Keep 0.5 cm of thread protruding.
ru
i
Applies to: Article no. 948111 – 948132, 948201, 948202, 948251, 948252.
ü Computer workstation is completely empty.
sl
1. Take lower storage shelf out of cabinet by lifting it at the holes on the sides.
CAUTION! Risk of cuts. Wear safety gloves.
2. Adjust four levelling feet inside the cabinet using a 5-mm Allen key.
3. Use a spirit level to check horizontal levelling.
sv
4. Repeat procedure until cabinet is perfectly level.
22
Werbung
