Adjusting Kombimotor For User; Fitting And Adjusting The Carrying System; Removing And Fitting The Battery; Inserting The Battery - Stihl Kma 200.0 R Gebrauchsanleitung

9 Adjusting KombiMotor for User

► Place the barrier bar (2) against the loop han‐
dle (3).
The barrier bar must fit flush against the loop
handle.
► Insert and firmly tighten the screw (1).
9 Adjusting KombiMotor for
User
9.1 Fitting and Adjusting the Carry‐
ing System
1
2
► Put on the shoulder strap (1) or full harness
(3).
► Adjust the shoulder strap (1) or full harness (3)
so that the carabiner (2) is about a hand's
width below your right hip.
Other approved carrying systems are listed in
this User Manual,
9.2 Adjusting and Setting the Loop
Handle
The loop handle can be set to different positions
to suit the height and reach of the user.
► Switch off the KombiEngine and remove the
battery.
3
0458-192-9801-A
4 3
2
1
3
2
21.
a
1
2
► Release the quick release clamp (2).
► Move the loop handle (1) to the required posi‐
tion and check that the following conditions
are met:
– The bump guard (3) fits between the loop
handle (1) and the carrying ring.
– If you are using a mowing head: a = 30 cm
max.
– If you are using a metal cutting attachment:
a = 25 cm max.
► Close the quick release clamp (2) so that the
loop handle (1) cannot be rotated on the shaft
any longer.
10 Removing and Fitting the
Battery
10.1

Inserting the Battery

► Insert the battery (1) up to the limit stop into
the battery compartment (2).
The battery (1) engages with a click and is
now locked.
10.2 Removing the Battery
► Set the KombiEngine on a level surface.
► Press both locking levers (1).
The battery (2) is released and can be
removed.
English
1
2
2
1
33