Activating And Deactivating Bluetooth® Radio Interface; Assembling The Kombimotor - Stihl Kma 200.0 R Gebrauchsanleitung

English
6.2 Displaying the charge level
1
► Press the button (1).
The LEDs light up green for about 5 seconds
and indicate the state of charge.
► If the LED on the right flashes green: Charge
the battery.
6.3 LEDs on the Battery
The LEDs can indicate the state of charge of the
battery or any faults. The LEDs can be steady
green, steady red or flashing.
If the LEDs are steady or flashing green, this
indicates the state of charge of the battery.
► If the LEDs glow or flash red: Troubleshooting,
19.1.
There is a malfunction in the KombiEngine or
battery.
7 Activating and Deactivating
Bluetooth® Radio Interface
7.1
Activating the Bluetooth
Interface
► If the battery has a Bluetooth
Press and hold the pushbutton until the
®
"BLUETOOTH " LED next to the
lights up blue for approximately 3 seconds.
®
The Bluetooth radio interface on the battery
is activated.
7.2
Deactivating the Bluetooth
Radio Interface
► If the battery has a Bluetooth
Press and hold the pushbutton until the
®
"BLUETOOTH " LED next to the
lights up blue six times.
®
The Bluetooth radio interface on the battery
is deactivated.
32
7 Activating and Deactivating Bluetooth® Radio Interface
80-100%
60-80%
40-60%
20-40%
0-20%
Radio
®
®
radio interface:
symbol
®
®
radio interface:
symbol
8 Assembling the KombiMo‐
tor
8.1 Mounting the Loop Handle
► Switch off the KombiEngine and remove the
battery.
1
9
4
8
7
► Guide the pin (8) into the gap of the quick
release clamp (5).
Align the pin (8) so that the groove of the pin
points down.
► Fit the clamp (3) in the loop handle so that the
holes align.
► Place the loop handle (2) with clamp (3) on the
shaft (9).
► Guide the long screw (7) through the bores in
the pin and in the quick release clamp (5).
► Press the clamp (4) against the shaft and align
it so that the holes are in alignment.
► Guide the short screw (6) through the holes.
► Guide the long screw (7) through the holes.
► Turn open the knurled nuts (1).
► Close the quick release clamp (5).
If the loop handle (2) cannot be adjusted any fur‐
ther, the loop handle is fixed.
► If the loop handle (2) can still be adjusted:
► Fold open the quick release clamp (5).
► Tighten the knurled nuts (1).
► Close the quick release clamp (5).
The loop handle (2) cannot be adjusted any
further.
► If the quick release clamp (5) cannot be folded
flat:
► Fold open the quick release clamp (5).
► Release the knurled nuts (1).
► Close the quick release clamp (5).
The loop handle (2) cannot be adjusted any
further.
8.2 Mounting the Barrier Bar
► Switch off the KombiEngine and remove the
battery.
2
3
5
6
0458-192-9801-A