Rear Panel - Sony mb-806a Bedienungsanleitung

Rear Panel

IN(DC 9V OUT)
0 10dB
ATT
6 5
ANTENNA B
1 ANTENNA A, B IN/DC 9V OUT (antenna A, B
input/DC power output) connectors (BNC type)
Connect the supplied antenna or an optional AN-820A
UHF Antenna. To connect two of these units, these
connectors are connected to the ANTENNA OUT
connectors of the WD-820A UHF Antenna Divider.
When the AN-820A is connected, 9 V DC power is
supplied to the antenna's internal booster through these
connectors.
Note
Never short-circuit these connectors.
2 ANTENNA A, B ATT (attenuation) switches
Select the RF attenuation as 0 dB or 10 dB.
Usually set the switches to 0 dB. If noise generates or
sound discontinues due to interference, set the
switches to 10 dB.
It is recommended that you set the switches as follows
depending on the antennas connected to the
ANTENNA A, B IN/DC 9V OUT connectors.
Using the supplied antenna: 0 dB
Using an optional AN-820A UHF Antenna (with a
WD-820A Antenna Divider): 10 dB when the coaxial
cable (5D-2V, RG-212/U or equivalent) connecting the
antennas and tuner is 30 m (100 feet) or less, or 0 dB
when the cable is over 30 m (100 feet)
4 3 2 1
TUNER OUTPUT MIX OUTPUT
5 MIX OUTPUT connector
6 TUNER OUTPUT connectors
1 ANTENNA A, B IN/DC 9V OUT connectors
2 ANTENNA A, B ATT switches
OUTPUT
LEVEL
MIC LINE
IN(DC 9V OUT)
–58dBm –20dBm
0 10dB
ATT
ANTENNA A
4 OUTPUT LEVEL switch
3 AC IN connector
Connects to an AC power source with the supplied AC
power cord.
4 OUTPUT LEVEL switch
Selects the mixed output level and tuner output level as
–20 dBm or –58 dBm.
Set this switch according to the input level of the
equipment connected to the unit.
5 MIX OUTPUT connector (XLR type)
Supplies mixed audio signals of six tuner units. You
can connect this to the audio input connector of a
mixer, amplifier or similar equipment.
6 TUNER OUTPUT (tuner sound output) (XLR
type)
Each connector supplies the audio signal from the
corresponding tuner unit. You can connect this to the
audio input connector of a mixer, amplifier, or similar
equipment.
3 AC IN connector
⁄
AC IN
5
(GB)