Channel Setting - Sony mb-806a Bedienungsanleitung

Channel Setting

Take the following precautions to prevent interference
and noise.
• If there is a TV broadcasting station nearby, to avoid
possible interference from its broadcasting, do not
use that station's channel.
• When simultaneously using two or more tuners,
always set the tuners to different channels within the
same group (other than group 00).
1
ON
OFF
POWER
1
Turn the POWER switch on.
The model version number such as "CE62" or
"CE67" appears on the display, and then the
current tuner status is displayed.
Note
Turn the POWER switch on after reducing the
volume of equipment connected to the TUNER
OUTPUT connector. Otherwise, noise will be
heard when the power is turned on.
8
(GB)
2 2,3,4
1
+
GP
AF BATT
RF
–
CH
GP CH
3,4
2
Press and hold down the GP button, and press the
+ or – button to select a group.
Each time you press the + or – button, the GP
indication changes as shown in the following
figure. To change the indication continuously,
press and hold down the + or – button.
–
GP CH
Display example of WRU-806B (CE62 model)
–
GP CH
Display example of WRU-806A (CE62 model)
–
GP CH
Display example of WRU-806A (AU66 model)
The CH indication shows the lowest frequency
channel of the selected group. For group 00,
however, the channel selected last is displayed.
Releasing the buttons automatically cancels the
group and channel selection mode, and the
currently displayed group is selected.
See "Wireless Channel Lists" on page L-1 (for WRU-
806A users) or refer to "Wireless Microphone System
Frequency List" supplied with the WRU-806B (for
WRU-806B users).
+
GP CH
+
GP CH
+
GP CH