Automatic Search And Setting Of Available Channels - Sony mb-806a Bedienungsanleitung

3
Press and hold down the CH button, and press the
+ or – button in 3 seconds to select a channel.
Similar to step 2, each time you press the + or –
button, the CH indication changes in the order
shown in the group and reception channel list.
See "Wireless Channel Lists" on page L-1 (for WRU-
806A users) or refer to "Wireless Microphone System
Frequency List" supplied with the WRU-806B (for
WRU-806B users).
If you press the + button when the last channel of
the selected group is displayed, the first channel of
the group will be displayed.
–
GP CH
Display example of WRU-806B (CE62 model)
Selecting the reception channel by frequency
Press the + button.
This changes the GP/CH indication to a frequency
indication.
To change a frequency, press the + or – button
while keeping the CH button pressed. (A higher or
lower frequency will be displayed.)
Press the + button again to change the frequency
indication to a GP/CH indication.
–
GP CH
Display example of WRU-806B (CE62 model)
4
If the desired channel or frequency is displayed,
release the CH button and + or – button.
The selected channel is set.
To store the selected group and channel
Leave the indication unchanged for 1 second.
The group and channel set in the procedure explained
above are stored in memory.
+
GP CH
+
GP CH
Automatic Search and Setting of
Available Channels
When you use the MB-806A Base Unit in a multi-
channel operation system, you can assign available
channels to all tuner units by operating the first tuner
unit only.
Note
Auto channel assignment function is available only
when the tuner base unit holds the tuner units in the
same TV channels.
1
Power off all wireless microphones and
transmitters.
2
On the first tuner unit, select the group to be used.
3
Press the CH button on the first tuner unit and hold
it down for 3 seconds.
The first tuner unit searches for available channels
in the selected group, and available channels in the
group are so assigned to all tuner units
automatically that two or more tuner units may not
use the same channel.
After automatic setting, you can adjust the groups
and channels of individual tuner units.
Notes
• Do not use group 00.
• If no channels are available, "NO CH" is displayed
and channel setting is aborted.
9
(GB)