Technical Data; Usage In Accordance With Intended Purpose - VOLTCRAFT PS 2403 Pro Bedienungsanleitung

Introduction
Dear Customer,
The design of this product meets the requirements of the low voltage directive
73/23/EEC. In addition, it has been tested for electromagnetic compatibility (EMC)
and thus meets the requirements of the applicable European and national directives.
Conformity has been proved and the corresponding certificates and documentation
can be obtained from the manufacturer.
To maintain this status and ensure safe operation, you as the user must heed these
operating instructions.
Usage in accordance with intended
purpose
• Connection of extra-low voltage consumers with operating voltages ranging from
twice 0 to 40 V DC and once 3 to 6 VDC at the safety sockets.
• The power consumption of a connected load must not exceed 3A on the "OUTPUT
A and B" power supply and 2A on the "OUTPUT C" power pack.
• All power supply outputs can be used independently of each other.
• The power pack is designed in compliance with protection class 1. It is only
approved for connection to shockproof sockets with protective grounding and an
alternating current of 230V~ /50 Hz commonly used in households.
• Operation is impermissible under unfavourable ambient conditions. The following
are unfavourable ambient conditions:
- Damp or humidity that is too high
- Dust and combustible gases, vapours or solvents
- Storms or stormy conditions such as strong electrostatic fields, etc.
Use other than that described above will damage the product and may involve other
risks, such as short circuit, fire and electric shock etc. Do not change or modify any
part of the product. The safety instructions must be observed without fail.
14

Technical data

Operating voltage:
Power consumption:
Output voltage:
Output current:
Residual ripple:
Stability:
Control response at:
change of load 0~100 %:
change of mains supply ± 10%:
Mains power fuse (5x20 mm):
Dimensions (W x H x D):
Weight:
Operating temperature:
Rel. humidity:
Protection class:
230 V~ / 50 Hz (± 10%)
450 VA max.
A: 0 to 40 VDC (-100 mV ~ 41.5VDC)
B: 0 to 40 VDC (-100 mV ~ 41.5VDC)
C: 3 to 6 VDC
A: 0.01 to 3 A adjustable
B: 0.01 to 3 A adjustable
C: 2 A (max.)
≤ 2 mV rms (rms = effective)
8 mV/h max.
≤ 30 mV / ≤ 10 mA
≤ 5 mV / ≤ 2.5 mA
slow burning 2.0A / 250 V
380 x 138 x 280 (mm)
approx. 10 kg
+5 °C to +40 °C
max. 85 (non-condensing)
1
23